Hello everyone,

I have a weird issue with a S7-1515F (6ES7 515-2FM00-0AB0).
Firmware: V1.7.0  TIA Portal Version: V16 and/or V17

The CPU is running properly. All the code is fine.
When I try to monitor online a custom safety function or function block the cpu goes into fault. Any block. The moment I press the monitor button it goes into fault.

First I thought it was my code causing the issue. So, I loaded a brand new empty project, created a basic safety function block (with one input - one output) and still I have the same issue. 

Initally I was using TIA Portal V17. I also tried TIA Portal V16 with no success.

I ve reseted to factory settings the CPU multiple times + format the memory card.

The two faults-events I am getting are:

Event ID: 16# 02:2505

Event ID:16# 0D:75D1

Has anyone encountered this problem before?

Hi JohnPrits,

The diagnostic data you provide is not really helpful. We would need more than two events.

However, when I read your descriptions, my first thought was cycle time? Perhaps your cycle time for the fail-safe programme is close to the allowed value. Please check this.

Kind regards
Stefan

Thank you for your suggestion.

Ive just tried the cycle time and does not make any differnece. 

Hi JohnPrits,

So please provide more details. Please save your diagnostic puffer and post the resulting file here.

Kind regards
Stefan

Hello again,

for future reference:

I just found a solution.

I updated the firmware to the latest one and it start working!