You need but only bit of the app to toggle. This bit you just have to TRG input of a pulse relay link (see attachment).

The attachment comes from the German forum, was created by user Helmut_13. Many thanks to him.

Hi,

Thats a very usefull example!

i tried this but there is a little bug in it i think, the 'ein' or on button in this example works like a momentary switch, so everytime you will press it you can switch the output. The 'aus' button doesn't work at all. Maybe its the meaning of this example?

Greetings,

This example is just to show you,

- How to converts a continuous signal to a pulse.
- How to turn with the same signal on and off.
- How to display the state of output in the button of the app.

Hi,

I know :) I'm very pleased with this example!

many thanks!!

Z.

Dear All , 

I used this exact example in an old application , and new with latest logo 8 and new Softcomfort I think this is not valid anymore. ~
Any ides how to use same principle but with New software and hardware. 

Thanks 

 okay then , I will try again. 

Thanks 

ixo65

 

Le Test !!

Dear All , 

I used this exact example in an old application , and new with latest logo 8 and new Softcomfort I think this is not valid anymore. ~
Any ides how to use same principle but with New software and hardware. 

Thanks 

I've tested it with the current LOGO! 8.3 (Firmware V1.83.02) and LSC V8.3.1.

It works also. But after some years I found a way with fewer blocks.