Hi

Do you have any suggestion about this? I have same problem that tried with 03 computer.

I tried with Sicam PAS 8.17 ( no hotfix), and it stop in "'GetNameList" , can not connect

Probably this Micom device is configured (or it's Firmware is supporting) only smaller size of PDU (MMS frame) as the size of the LN description

Please give me some suggestion to solve problem

Thanks

------------------------------------------------------------------------------------------
Split from SICAM PAS connection to Micom P543 IEC-61850 Case Failed to Connect.

Hi

Please check with log file with IEC Browser and IEDScout

The IEC Browser only get Logical Device, can not get the Logical Node
The IED Scout can get both Logical Device/Logical Node

I tried with Sicam PAS 8.16, the result same as IEC Browser : 
+ Only get Logical Device if the mapping uncheck any signal
+ Can not get Logical Node if mapping 01 signal

I tried with Sicam PAS 8.17 , can not connect to device with/without mapping any signal.

Please check attachment and give us advice

[snip]

Thanks and regards

Hi

Could you please tell me where the client connection timeout settings are managed for SICAM PAS, and Siemens IEC Browser ?

I need to change to test with IEDs P443.

Thanks and regards

Hi

We have tested that the A8000 61850 client can connect to the P443 that Sicam PAS can not.

Could you please give me some advise to compare how is different?

Another question : how to use A8000 61850 client <--> 61850 server to transfer to Sicam PAS
We did by logic inside A8000 but the timestamp from P443 to Sicam PAS are delays ( not same)

Thanks and regards

Hi

Someone help me !

or Can I send email to local Siemens for supporting ?

Helly skywalker,

I think it's a good idea to contact Siemens/ create a support request.