Dear,

I'm using a 1500 CPU mod. 1513F -1 Pn and a ET200S. On the ET200S are installed some digital and analog IO modules and I'm getting problem with the 6S7134-6HB00-0DA1 module. The project has been developed with TIA v17.

To the 6S7134-6HB00-0DA1 module with dark base at the fitst shannel, has been connected a 4-20mA pressure transducer in two wire way. In the hardware configuration the channel nr.0  the "Current (two wire transducer)" option is selected, 4-20 mA range option is selected and none option in smoothing is selected. For that channel all the flag in the diagnostic form are selected such as no supply voltage L+, short circuit to ground, overflow, underflow and wire break.

The transducer has been connted following the Siemens instruction manaual as shown on page 19 connecting it to the 5 and 9 pin; no other connections has been done. So I'm getting the Wire Break error in the 6S7134-6HB00-0DA1 module but the connections sill ok.

Why I'm getting the Wire Break error? Are there other connections to be done in the module?

Thank You for help

Luca

Closed cause question posted twice.

The second thread with the subject Problem with analog input is published within the conference Decentral Peripherie.