Hello,

I have had a working logo 6ed1052-1md08-0ba0 with firmware 1.82.02 (fs02) and after creating and uploading a new project it stoped working.

Now after power up there is only blank screen, and when I press and hold "esc" key there is a message "detecting..." for a couple of seconds and then screen turns off.

The Logo is also doesn't seen on LogoSoft Comfort.

How can I bring it again to life ?

ixo65

I haven't heard of such an error before.

What does "blank screen" after switching on mean? Is there nothing to see at all?

Can you still get to the system menu of LOGO!?

 The screen is clear from the begining of power up, there is nothing on it and also backlight is off.

I cant get to any menu because nothing is visible. Only after pressing ESC key there is msg "detecting..." for couple of seconds.

The led LAN blinks faster if cable is connected, and also rarely in disconnected state.

How did you transfer the program? Via network cable or SD card?

If via SD card then check if the pins are bent. Start the Logo sometimes without a SD card.

If you used a network cable, send a ping to the logo. If she still doesn't answer something is broken. The only thing left for you to do is buy a new one.

Ella_68