Hello every body

i have a problem with sumo drive 611 control card 6sn1118-1NJ00-0AA2  1 axis position mode resolver I try to change its profibus address and some parameters through simocomu after that that error massage appear  A-831 no data exchange through profibus system 

I make sure every configuration is ok but the same problem happen again 

What do you think the problem is?

by the way the profibus network is ok and I access the simodrive through profibus .

your help is highly appreciated 

Hello every body

No one can answer 

by the way i solve the problem and the error is gone (see the attached picture)

the problem was in "Expected option module type" was 3 and it must be 2 for the used optional profibus module .

[snip]

New question published by engineeeer is split to a separate thread with the subject Error A 608 , A 131 and A 130.

Best regards
The Helping Hand