I have a communication problem on the Atlas Copco compressor between the Elektronikon 5 graphic front panel and the Masterdrive CUVC Siemens inverter. The problem appeared just after the drive was reset to factory settings via the parameter P970.

Is there a way to restore the old parameters or shall I ask Atlas Copco to send me the parameters file so that I download it into the drive by using the DriveMon software?

Any suggestions

 Is there a way to restore the old parameters--Yes, you can transfer by "Drive monitor" SW, and you can manually input (1 by 1)--and you can ask machine builer "Atlas Copco" if the 3rd party "Elektronikon 5 graphic front panel" can store the parameters,

Baisclly you need ask them to give your parameters

Vvicken

I have a communication problem on the Atlas Copco compressor between the Elektronikon 5 graphic front panel and the Masterdrive CUVC Siemens inverter. The problem appeared just after the drive was reset to factory settings via the parameter P970.

Is there a way to restore the old parameters or shall I ask Atlas Copco to send me the parameters file so that I download it into the drive by using the DriveMon software?

Any suggestions

Dear Sir,

Can you tell me the update of this problem and how to solved it ??
because I had the same problem with Atlas and Keaser compressor .