Hello Mr. Hieu,
I am communicating G120 with CP343-1, 
Hardware has reported Ok configuration Do I have a telegram 
that can directly access the address? Or do I have to use 
command blocks FC11, FC12? 
Thank you sir,

------------------------------------------------------------------------------------------
Split from Profinet with CP343-1 and SINAMICS G120C.

Closed cause question posted twice.

The second thread with the subject G120C with CP343-1: Can I read and write I/O addresses directly installed in the Hardware section? is published within the conference SINAMICS G.

Best regards,
Jen_Moderator
​