Hello everyone.

With the old winCC panels, all the alarms had events. With these events you could set a bit to be true when the alarm was incoming, and reset the bit when the alarm was acknowledged (please see attachment).

You could highlight as many alarms as you please, and apply this event in one go. In less that a minute, you could configure an alarm sounder logic for all your alarms.

It worked very well, and was very efficient.

Now, with the unified panels, there are no alarm events. 

Is it possible to do what I described above with a script? 

I am new to the unified panels. Any help/advice would be greatly appreciated.

Thank you

Kyle

Hi Murof,

I just figured this out! 

Thank you anyhow 

Cheers!

Kyle