Ziemens

We are trying to change the active drive object on the BOP top left.
It says in the “Commissioning Manual 07/2007”:
– Press key "FN" and "Arrow up" -> the drive object number at the top left flashes
– Select the required drive object using the arrow keys
– Acknowledge using the "P" key
But it is not working, nothing is flashing.
Please advise what to do.Thanks

Yes, in order for the BOP to change drive object numbers, the CU320 must first be "told" what drive objects exist. This can either be done via automatic configuration through the BOP (reads everything on Drive-Cliq), or by downloading a project via STARTER.

Description:
Sets the access level for reading and writing parameters using the Basic Operator Panel (BOP) and Advanced Operator Panel (AOP).

Values:
0: User-defined
1: Standard
2: Extended
3: Expert
4: Service

Note:
Access level 0 (user-defined):
Parameters from the user-defined list (p0013). Not used as of firmware version 2.6 (p0016).
Access level 1 (standard):
Parameters for the simplest operator control possibility (e.g. p1120 = ramp-function generator, ramp-up time).
Access level 2 (extended):
Parameters to operate the basic functions of the drive unit.
Access level 3 (experts):
Expert know-how is required for these parameters (e.g. BICO parameterization).
Access level 4 (service):
For these parameters, it is necessary that authorized service personnel enter the appropriate password (p3950).