SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

FM 350-2 Hardware monitoring

10/3/2011 3:37 AM	Rate (0)
Rudi1234 Posts: 12 Rating: (1)	Hi I have a FM 350-2 counter card in my project. Everything is connected as the manual explains, but the signal from the encoder is not coming through. Is it possible to monitor the incoming signal from the hardware config? In the counter software there is a 'commissioning' option. When I open that and set the mode to Run and Stop, should the LED indications come on? Everything stays blank in the commissiong window. Also, on the physical card, should the LEDs flash when there is an incoming signal? At the moment the connected channel's LEDs are all off. Your help would be much appreciated! Thank you!
Rudi1234 Posts: 12 Rating: (1)
Suggestion To thank Quote Answer

10/4/2011 11:38 AM	Rate (0)
Silent Bob Posts: 836 Rating: (100)	There are several manuals and FAQ concerning FM 350-2. Check them out at the Service and support page. Are you sure the Signal is comping to the module?
Silent Bob Posts: 836 Rating: (100)
Suggestion To thank Quote Answer

10/10/2011 7:22 PM	Rate (0)
tomus50 Posts: 49 Rating: (0)	there aren't any led's to indicate input. i too, am having problems with this modual.
tomus50 Posts: 49 Rating: (0)
Suggestion To thank Quote Answer

10/11/2011 12:05 PM	Rate (0)
PLCnoob Posts: 26 Rating: (1)	Rudi1234 Hi I have a FM 350-2 counter card in my project. Everything is connected as the manual explains, but the signal from the encoder is not coming through. Is it possible to monitor the incoming signal from the hardware config? In the counter software there is a 'commissioning' option. When I open that and set the mode to Run and Stop, should the LED indications come on? Everything stays blank in the commissiong window. Also, on the physical card, should the LEDs flash when there is an incoming signal? At the moment the connected channel's LEDs are all off. Your help would be much appreciated! Thank you! Look if you enabled the software gate. You can check it in the Counter DB. if this is enabled and you cant see any thing coming true you probarly turned on "Use hardware gate". this means that you need an discrete input on your card to be high so the signal will be detected.
PLCnoob Posts: 26 Rating: (1)
Suggestion To thank Quote Answer

Share this page:

Share this page on...