I have a PCS7 Engineering station running version 6.1. I have no problem doing a compile with generatemodule drivers selected for the dual slot PCS7 In A Box using a 6ES7 616-2QL10-0AB4 CPU 416-2PCI dual slot

I want to create a a project for the the single slot controller. I downladed and installed the HWUPDATES and the controller appears in my when I go to the hardware configuration. When I create a project on the dual slot cpu appears in the project wizard, so I created with the dual slot cpu and the changed it to a single slot cpu in the hardware config. When I go to compile a CFC with generate module drivers I the following error message.

W:CPU 416-2 PCI (6ES7 616-2QL10-0AB4) is not supported.
E:Parameter ENRACK0 that must be interconnected with parameter IN1 of block PC_1 does not exist.
E:Parameter SUB0DIAG that must be interconnected with parameter SUB_DIAG of block PC_1 does not exist.

I believe the 2 errors are a cuased by the the new cpu not being supported. I'm not sure if this is the problem, but when I install the HWUPDATES they appear to install (the show up in the Hardware config) the the dialog box will not close after the installation. I need to close it in the task manager.

Any thoughts on how to fix the error message?

Thanks