SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

6RA70 drive enable & speed reference

6/16/2012 12:43 PM	Rate (0)
Patidar Posts: 42 Rating: (0)	Dear All, I have an application where I receiv drive run command (24VDC) & drive reference voltage (0-10VDc) together. In this application 6RA21 drives run properly but 6RA70 drive does not. Can 6RA70 drives run properly if it get drive enable & speed signal together? Please suggest. Thanks
Patidar Posts: 42 Rating: (0)
Suggestion To thank Quote Answer

6/16/2012 4:39 PM	Rate (0)
KSN Diamond Expert Joined: 8/25/2006 Last visit: 12/26/2025 Posts: 2221 Rating: (282)	Hello. Yes, it is possible with default configuration of control word bits, if you have already applied ON command to the drive (from terminal 37). For more details look at themanual, function diagram G180.

Suggestion To thank Quote Answer

7/8/2012 8:21 AM	Rate (0)
Patidar Posts: 42 Rating: (0)	Thank you for Suggestion & manual terminal 37 is kept ON always & control the drive enable at terminal 38. Which parameters I need to change to resolve this? If I put the drive in default setting then would it work?
Patidar Posts: 42 Rating: (0)
Suggestion To thank Quote Answer

7/8/2012 11:14 AM	Rate (0)
PISCEAN 2010 Posts: 8092 Rating: (884)	Yes with default parameters it should work. Only you will not be able to configure OFF1 mode. Please check.
PISCEAN 2010 Posts: 8092 Rating: (884)
Suggestion To thank Quote Answer

Share this page:

Share this page on...