Hi,

I am trying to transfer visualization program to C7-635 control unit using protocol software it is not getting connected and the program is not able to transfer. with the same PG if load PLC program the communication is working fine.

In set PG/PC interface I am selecting Step7-Cp5611(MPI) protocol for the transfer.

Can anyone suggest any other things to check for establishing communication and transferring the program.

Thanks & Regards,

Ravindra.

Hi,

yes the panel is in transfer mode and the MPI communication addresses is set as 1 and panel is the only master on bus is selected with baud rate of 187.5 KBPS and High station address is selected as 31.

Thanks & Regards,

Ravindra.

Hello Suhas,

In addition to Wizard have  a look the manual page 5-4 Step 6. :

C7-635 Control System