hello dears

i want to connect my logo oba8 to wincc but i dont know what must i do??

i connect my logo to pc and connection is okk??

in my wincc and tag managment i use chanal s7 protocool suite and tcp/ip

and then i enter my pc ip in connect .after it i make to tage input and output .

but when i run the runtimr wincc there is not connection between my logo and wincc

please help me .i need this emergency

Look at this siemens web side.

http://w3.siemens.com/mcms/programmable-logic-controller/en/logic-module-logo/application-examples/Pages/Default.aspx

There is an example:

HMI communication starting from WinCC V11.x (TIA Portal)

New question published by moghimi is split to a separate thread with the subject Connect logo v8 to wincc v7.2.

Best regards
Min_Moderator