Navigation
Rating 
Thanks 2
3 Entries
| 4/28/2016 12:25 PM | |
|
Posts: 142 Rating:
|
Please tell me parameters of cuvc drive for setpoint,mode and encoder. |
| 4/28/2016 1:05 PM | |
Joined: 3/17/2013 Last visit: 4/28/2025 Posts: 481 Rating:
|
Hi Hope you are referring about MM440 Check the link below http://www.siemens.no/ccmi/bu/ad/pdf/f/MM440_Parameterlist_0106.pdf P1000 is for Setpoint, P1300 for Control mode and P0400, P0408,P0491-P0494 belongs to encoder like PPR.. Vijay |
This contribution was helpful to
|
|
| 4/28/2016 1:45 PM | |
|
Posts: 8092 Rating:
|
Please check below manual, section parameter list. SIMOVERT MASTERDRIVES, MOTION CONTROL, COMPENDIUM |
This contribution was helpful to
|
|
Follow us on