hi to all I would like to make a program as bellow 

Activating a digital input to lead an inverter b.c with 3volt (analog output off logo) for 2 minutes (T1)after

this timer for another 2 minutes (T2) to drive the inverter with 5 volt and finaly for 1 minute(T3) drive with 10volt

 could someone give me an example of program ;

first of all thank you for the important help 

I would like to ask you three more questions

a. Can i write this program manually without using software ?

b.If i buy the software with part no 6ed1052-1md00-oba8 can i programmable the logo via rj 45 plug of my laptop?

and c. Should I have to declare the analogue expense card with part no 6ed10551mm000ba1in my program ? or place it on modul with part no 6ed1052-1md00-oba8 and transfer direct to it the program that you sent me ?

in position 2 I will activate the digital input 2 I will use as the basis the program you wrote to me by simply changing the timers and the voltages and I will activate the analog output AQ2

n the 3rd position I will activate the digital input 3 I will use again the program you wrote me by simply changing the timers and the voltages .My question is In this case can i use again or AQ1 or AQ2 

Or will i  have to buy an extra analogue output modul ? 

(Note that in my application each position of the selective switch will be like changing a recipe with ingredients (timers and voltages)  from one operator panel)