SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

How to change the drive parameter, while the drive is running?

9/14/2012 10:26 AM	Rate (0)
Gorib Posts: 3 Rating: (0)	Dear Hristo, the drive is integrated into shore power converter Mastervolt on the boat. The boat frequency and voltage is 208V/3ph and 60 Hz, and on the shore side can be from 170 V to 540V at any 50-60Hz. I would like to replace the board because the fault that I described before is FF05 and this is more likely to be the CUVC malfunctioning as per the last consultation that I received. As I said, when the board is in FF05 state, I can't read anything on the OP1S and the drive doesn't want to start, Thanks Regards Georgi
Gorib Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

9/14/2012 10:34 AM	Rate (0)
Gorib Posts: 3 Rating: (0)	Hi Graeme, I changed P053 to 0111 and tried to change P60 to 7 but still doesn't accept it. The value of P358.1 is 3 and P358.2 is 146E. Do they mean anything. Do we have anything like default values on those two parameters? The converter is assembled by Mastervolt and I will have to get in touch with them for the passkeys. The converter had been installed and commissioned by Imtech Holland but they refused to assist. Yes the fault is FF05. Thank you Regards Georgi
Gorib Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

2/8/2018 7:50 AM	Rate (0)
Jen_Moderator Posts: 8171 Rating: (174)	New question published by DK Sarraf is split to a separate thread with the subject How to change the r61001 parameter for communication to the intouch without any software?. Best regards Jen_Moderator
Jen_Moderator Posts: 8171 Rating: (174)
Suggestion To thank Quote Answer

Share this page:

Share this page on...