kkoos

I deleted C:\Program Files (x86)\Common Files\InstallShield\Driver\11 folder and tried it again
.

Worked for me too.

Hi,

I am having a similar issue, exact same error message but using PCS7 V8.1 SP1, Step7 V5.5 and trying to install F-System V6.0.

I have tried removing folder 11 but no luck, still get the same error.

Any ideas?

Hello,

F-System V6.0 is not compatible with PCS7 V8.1 and not compatible with Windows 7 x64.

Regards

Christoph

Hi CristophD,

Thanks for your speedy response. This is the first project I am doing using H PLC's and PCS7 Integrated Safety. Perhaps you would be able to steer me in the correct direction.

I have received a backup of the existing project but when I open a CFC chart it is blank. I have been advised that this is because I do not have PCS7 Integrated Safety. I have also been told that S7-Distributed Safety is not compatible with PCS7. Is this correct? And what would I need in order to have Integrated Safety?

Thanks in advance,

Lawrence

Hi,

yes if the Safety program is written in CFC you can't use the distributed Safety.

For Windows 7 x64 and PCS7 8.1 you should use F-System V6.1 SP1, this version is compatible and released for Win7 x64 and PCS7 V8.1.

Regards

Christoph

Hi,

Thanks a lot. This solution was succesfull for me.

Best regards.

kkoos

I had problems installing the safety software also. I found another post that worked for me.

I deleted C:\Program Files (x86)\Common Files\InstallShield\Driver\11 folder and tried it again.

/tf/WW/en/Posts/69586

 Thanks!
This worked for me too

Thank you so much.. It works for me too.

kkoos

I had problems installing the safety software also. I found another post that worked for me.

I deleted C:\Program Files (x86)\Common Files\InstallShield\Driver\11 folder and tried it again.

/tf/WW/en/Posts/69586

 thanks, it works!