Dear All,

I would like to connect a TA3115 Temperature transmitter to a Analog Input Card (6ES7 331-7NF00-0AB0).

I do not know how to do that. I wanted to use 4-20mA signal with 1 wire, but it looks to me it is not possible.

Here is a link about the sensor:

https://www.ifm.com/il/en/product/TA3115

For some reason I could not upload a picture, despite the fact, that the size of it is just 800 kb. So I have 4 wire coming from the sensor. A white (as I know the current is coming on this), black, blue, and brown (+24V).

Could you tell me how to do that? Which wire goes to where? Do I need to use a scaling function to scale after I wired the sensor? 

Best regards,
Tibor

AutoGen_4087331

Dear All,

I would like to connect a TA3115 Temperature transmitter to a Analog Input Card (6ES7 331-7NF00-0AB0).

I do not know how to do that. I wanted to use 4-20mA signal with 1 wire, but it looks to me it is not possible.

Here is a link about the sensor:

https://www.ifm.com/il/en/product/TA3115

For some reason I could not upload a picture, despite the fact, that the size of it is just 800 kb. So I have 4 wire coming from the sensor. A white (as I know the current is coming on this), black, blue, and brown (+24V).

Could you tell me how to do that? Which wire goes to where? Do I need to use a scaling function to scale after I wired the sensor? 

Best regards,
Tibor

 Why don't you look at the Analog input manual, and the sensor manual, end see the connection examples?

Hello!

Yes, you are right. Yesterday I did not understand it, but today with fresh mind I got it!

Thank you!

I will try it. It should work.