Hi Chris,

I have winccflex intergrated with S7PLC. Can you tell me step by step how to migrate? Thanks

ChristophD

hi,

if you have the original project in ES(Protool or winccflex) then yes is possible to migrate.

If not then is not possible.

regards

christoph

------------------------------------------------------------------------------------------
Split from TP177A 6" Migration to TP177B PN/DP.

in tia click on migrate project

select the s7p file from the project you want to migrate

activate checkbox "include HW Config"

start the migration

for that migration all needed sw (ste7 V5.x Winccflex TIA Step7 tia incc) must installed on the same system.

Hi Chris,

Mine is different case. I have Step7 V5.5, WinCC Flex2008. I wanted to migrate TP177B DP to TP177B PN/DP. I found device setting in WinCC and change it to TP 177B PN/DP. When I do  Project>>Transfer>> Transfer to download program to HMI. It gives a problem that connection could not establish. Is there something wrong with what I did? Pls advise

without further information, hard to say.

how you connected to the panel?

panel is boot up and in transfermodus?

hi,

panel displayed in accessible nodes?
which settings you use for download?