Hi all,

I have this CPU S7-1513F-1PN es7513-1FL01-0AB0.

When i connect to 24V DC, the display power on but all leds are off.

I try to connect with ethernet for upgrade firmware or reset the CPU but ethernet not function and leds not blink.

This CPU works good for two month, but is out of garancy because is old.

What can i do to solve this problem ? Is possible that the firmware is block ?The problem could be the internal power supply?

Thanks 

Hello,

you are right that ist could be the internal power supply.

Please look fort the diagnosis at the display.
Can you see there any error?

regards
CaOd

Display doesen't  show any message, It showing Connecting.

Is possible to repair the internal power supply ? There is a fuse ?

same problem... is there any solution?????

i have same problem too

is any update about fix?

Ioannis.Strou.Fanuc

same problem... is there any solution?????

did you find any solution for your problem?

I have just experienced this same exact problem with same PLC model. It happened to me after removing the memory card while in RUN mode. I am guessing that caused it...Siemens support recommended replacing the PLC.

dany3007

i have same problem too

is any update about fix?

Hello All,

I had the same problem, but still no clue of what could cause it.