I'm entering the CMR on webpage, by its IP address.

i can change the password in -> WAN-> SMS-> "Password for writing commands". i unchecked the box named "Enable SMS password", so i guess you can write without password. Now i checked the box, and made the password 123 so, same still happends.

Now i'm sending "123;LOGO=VM15,1,BYTE

Answer is "LOGO=VM15,1BYTE: No Success"

The VM is a NQ, in my program, i havent configuered anything beside dragging it and change address. is it a problem, its a local VM Address?

How would you make a VM for an output, in LOGO BM?

Can it be the firmware? 

Still gives the same answer. 

I attached a picture of the address.

Somehow it feels like it can't connect. The "no success" means in CMR2020 manual, Values could not be set or read ". so i guess the connection is fine, but the VM is not?

Thanks for helping.

Hello,

So you write to address vb10?

Best regards,

Wizard

screenshot of message from mobile 

First one is writing to CMR2020 modules Output, and it works fine.

Second is to logo, and ain't

Yes, i've read the chapter 4.2 and more.

i dont see the difference than the manual for CMR2020.

as i understand, i dont need to make any actions, events, or assingsments for writing to a VM, am i correct? its only for read/SMS/alarms.

The two pictures i attached in the previues messages, shows how i addressed a VM, and trying to write to it.

EDIT: You're completely right. what i thought i didnt have to, i DID have to. Thank you so much for great support.

yes it is. I didnt think it was nessesary to write the VM-address in Monitoring-> signals - to write to it, only for read. Now i've learned i'm wrong :) apparenty i'm not that good reading manuals as i thought.

Have a nice day