Navigation
Rating 
Thanks 0
4 Entries
| 11/18/2022 5:39 PM | |
|
Posts: 1 Rating:
|
Helo dear all I use Siemens 802d sl controller for 3 axis milling machine with 2 additional axis for tool changing system. Tool change doesn't work when I bout this machin as stock. I think due to mechanical proble, related axis have been deactive. FG light on BOSCH drive is off, in the event that simillar green light other drives are on. I put MD 30130 (CTRLOUT_TYPE) 0 to 1 and put MD 30240 (ENC_TYPE) 0 to 1. But V axis can't move in tool change program yet. Pleas tell me which other machine data I must change. Or which software and hardware problems maybe have occored?
Thank you ------------------------------------------------------------------------------------------ |
Last edited by: Jen_Moderator at: 11/21/2022 09:03:47New subject after splitting |
|
| 11/27/2022 1:29 PM | |
Joined: 10/17/2007 Last visit: 1/19/2026 Posts: 4579 Rating:
|
|
|
If you like my comments please |
|
| 11/28/2022 3:20 AM | |
|
Posts: 8092 Rating:
|
PM sent, pls check. |
Follow us on