Navigation
can not communicate the plc with the HMI simulation
Created by: AutoGen_1771241 at: 5/24/2023 5:21 PM (4 Replies)
Rating 
Thanks 0
5 Entries
| 5/24/2023 5:21 PM | |
|
Posts: 3 Rating:
|
Hello, I've got the same problem. I solved it before, but now using the same steps I can not comunicate the plc with the HMI simulation. Any suggestions? ------------------------------------------------------------------------------------------ |
Last edited by: Jen_Moderator at: 05/25/2023 07:59:53New subject after splitting |
|
| 5/24/2023 5:25 PM | |
Joined: 5/12/2006 Last visit: 1/19/2026 Posts: 22827 Rating:
|
solution was in the post above if they not solve your problem you have not the same and you should provide more deteils |
| 5/25/2023 6:30 AM | |
Joined: 5/6/2022 Last visit: 1/15/2026 Posts: 589 Rating:
|
Hi AutoGen_1771241, Next I am going to share a FAQ that can help you, since it deals with the same problem that you are experiencing: Hope that helps. If not, answer us and we will look for other solutions. Best regards!
|
|
If this Information really helps, you could use the Rate function |
|
Follow us on