Dear Sir

I am trying to connect my S71200 KIT with ethernet cable to wicc v7.3

by doing :

Tag Management<<Add new driver>> then select <<SIMATIC S7-1200, S7-1500 Channel>> then add new connection under "OMS+", open "Connection Parameters" to configure the IP address.

the problem is:

The Select the Access point to "S7ONLINE" does not appear , instead i get (CP Ch_1 and PLCSIM)

How could i solve this problem please

Dear Georg Berghof

Thank you so much, your answer was very helpful

regards

New question published by Robanel is split to a separate thread with the subject Trying to connect wincc 7.3 with PLC S7-1200 .

Best regards
Jen_Moderator