SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Changing new MM

5/16/2016 4:01 AM	Rate (0)
Ravi123@ Bronze Member Joined: 6/11/2007 Last visit: 2/7/2025 Posts: 62 Rating: (7)	Hello We have Sinamics S120 system with following configuration CU320-2DP Motor Modules-02 Nos. Recently there was fault with one of the motor module and we need to replace the same with new one but different MLFB OLD :-6SL3120-1TE31-3AA3 /85 Amp NEW :- 6SL3120-1TE28-5AA3/132 Amp What procedure in starter should be followed to change the motor module parameters only. Does simply entering the ID of new motor module in P0201 is sufficient.
	Last edited by: Ravi123@ at: 5/16/2016 4:04:52 AM Last edited by: Ravi123@ at: 5/16/2016 4:09:53 AM Thanks Ravi
Suggestion To thank Quote Answer

5/16/2016 5:32 AM	Rate (0)
Jeff Casagrande Posts: 1529 Rating: (203)	I would go through the entire configuration process and re-commission, as your drive specific parameters with respect to the motor have now changed (current limit, current controller, speed controller, etc.)
Jeff Casagrande Posts: 1529 Rating: (203)
Suggestion To thank Quote Answer

3/21/2025 11:19 AM	Rate (0)
@AutoGen_979917 Joined: 3/21/2025 Last visit: 3/21/2025 Posts: 2 Rating: (0)	Dear Mr. Ravi, I also seeking for the solution of same if you found the solution for the problem. Please share here.

Suggestion To thank Quote Answer

Share this page:

Share this page on...