Hi team good evening

After configuration sinamics S120 I faced an error switching on inhibted set OC/OFF=1 "P0844,P0845"

Hello,

it is not error, drive is waiting for enables.

But you have a mistake - parameters p844, p845 are  OC/OFF2 signals. You have to first switch both these parameters to enable state (also OC/OFF3 should be enabled) and than, with rising edge on OC/OFF1 signal, start the drive.

Check also other missing enables in parameter r46.

With regards

Martin

How to enable P0844 and P0845 ??? Let me know please…