SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Operator Panel OP 7-DP

2/25/2010 4:22 PM	Rate (0)
jimshack Posts: 3 Rating: (0)	Upon power-up of this hmi panel the display just reads' Ready For Transfer' and does nothing else. Has anyone had this problem. I get the same message whether the panel is linked to the plc or not. It seems to hangup at an early stage of boot. Could it be the firmware is corrupt?
jimshack Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

2/25/2010 4:38 PM	Rate (1)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 1/20/2026 Posts: 9106 Rating: (1204)	Dear jimshack, Seems to be no project on panel anymore. You will have to download project again. Best regards, Wizard

Suggestion To thank Quote Answer

2/25/2010 6:24 PM	Rate (0)
jimshack Posts: 3 Rating: (0)	Thank you, I thought it would be something like that.
jimshack Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

2/26/2010 5:12 AM	Rate (1)
Ayman Elotaify Diamond Member Joined: 5/28/2008 Last visit: 1/14/2026 Posts: 4522 Rating: (843)	Hello, I am agree with Wizard. And this could be happen if somebody have erased the project from the OP using [ESC + Right arrow + Down arrow] during OP start up. Regards,
	Last edited by: Ayman Elotaify at: 2/26/2010 5:12 AM Ayman Elotaify
Suggestion To thank Quote Answer