HOW TO COMMUNICATE S7200 AND SINAMICS G120 USING USS PROTOCOL

Recommendations for reliable RS485 communication between S7-200 and MICROMASTER 4 / SINAMICS G110 / SINAMICS

Function Blocks, Examples and User Manuals of the Serial Interface ET200S 1SI

They will show you how to connect to a drive using USS Protocol and RS-485 electrical interface, applicable to the1SI module even though the posts are designed for the S7-200 CPU, and how to program (and download the required blocks) for the ET 200S 1SI miodule.

Hope this helps,
Daniel Chartier

dchartier

Hello Cihan GARIP;

Please have a look at the following documents.

HOW TO COMMUNICATE S7200 AND SINAMICS G120 USING USS PROTOCOL

Recommendations for reliable RS485 communication between S7-200 and MICROMASTER 4 / SINAMICS G110 / SINAMICS

Function Blocks, Examples and User Manuals of the Serial Interface ET200S 1SI

They will show you how to connect to a drive using USS Protocol and RS-485 electrical interface, applicable to the1SI module even though the posts are designed for the S7-200 CPU, and how to program (and download the required blocks) for the ET 200S 1SI miodule.

Hope this helps,
Daniel Chartier

https://www.automation.siemens.com/mdm/default.aspx?Language=en&GuiLanguage=en&DocVersionID=30303190923&TopicID=14455800203&Highlight=&Query=&cssearchengine=NEW

I did it by using the link above, such as blocks. Rx and Tx signals SI module is 1. SINAMICS V20 speed control device, such as start and stop, but the communication is not secured. Additional images are also available on the use of the blocks. Waiting for answers on the subject.

Thank you for your interest.

Best Regards

Cihan GARIP