Hello

I have problem in Simotion D410-2 DP/pn, the power was disconnected from the machine for about 20 days and when the power is back.

The led states are as 

RDY  flash red

Runstop yellow ON

Out-5v green ON

SF/BF OFF

Thanks

Hi

I found in the manual that

"SINAMICS Integrated in fault state(Check parameterization/configuration)"

So what may be the problem?

And the power was off from the Simotion for along time.

What may be happened?

ChristophD

go online to the device an check which fault are present , thern fix it.

 I find in  the device diagnostic error 20005 bit 0 encoder number0 reason 0x1h. I think problem in Encoder of drive, I change the motor with another motor and the same problem. 

So what is the problem? 

ChristophD

go online and check which fault is present in sinamics 

Hi, 

How to go online with sinamics? When I open the diagonsic, I choose simotion, should I open it and choose the sinamics? 

 If I want to change the sinamics that integrated in simotion 401-2 can I do this and the software is protected I can't upload the project (no project to open) 

Thanks

 If it is a pure Sinamics problem then you can scan for online devices (using scout or starter) and when you find the sinamics integrated, upload it and then try to see if there are troubles

Mahmoud Mosad

 

ChristophD

go online and check which fault is present in sinamics 

Hi, 

How to go online with sinamics? When I open the diagonsic, I choose simotion, should I open it and choose the sinamics? 

 If I want to change the sinamics that integrated in simotion 401-2 can I do this and the software is protected I can't upload the project (no project to open) 

Thanks