Hi to everyone,

I use a linear actuator that gives position information as a 0-5V analog signal. I get the location information from I8

Actuator operates between 2-98 mm. 

I want the actuator at 98 when the system is first opened.

From the TDE screen, the point where the actuator will go can be determined

Using the f1 and f2 keys of the TDE display, I want to take the

actuator anywhere between 2-98 mm

Q1 moves in the forward direction, Q2 + Q1 moves in the reverse direction.

Also, if possible, I would like him to get information about where to go from excel. Is it possible?

I use 12/24 VDC LOGO! 8FS4 

Sorry for my bad English.

Thank you for your help.

Hi İxo65,

I will try to declare its target as an analog signal. 

It may be a problem if the actuator accelerates and moves too much at a time in small position changes. I'm using a driver. If the target to be reached is below 10 units, it should be slower.

the program will be a bit complicated

I am not very successful in analog signals but I will try to create the program.

Thank you for the answer...

In actuator, position information can be 0-5V analog signal. 

would it be a problem for this LOGO!?

Understood. Thank you for the information you provided.

I am working on it.

If I can't do this, I can ask for help again...

New question published by CumhurOnbay is split to a separate thread with the subject What are the settings to do when receiving data over Modbus TCP/IP? .

Best regards
Jen_Moderator