Rating 
Thanks 1
4 Entries
| 7/2/2021 10:50 AM | |
|
Posts: 19 Rating:
|
Dear all Could anyone help me to understand clearly about subroutine 46_PI_SERVICE & SUB 43_MEAS_JOG? I have gone through the commissioning manual but it is not clear to me how I can apply this? Kind regards ------------------------------------------------------------------------------------------ |
Last edited by: HAFIZA at: 07/02/2021 10:52:36Last edited by: Jen_Moderator at: 07/02/2021 11:32:09New subject after splitting |
|
| 7/2/2021 11:37 AM | |
|
Posts: 8092 Rating:
|
Hello, SUB_43 - Is used to process the information from measuring probe. User can use this to calibrate probe & measure a tool. Please refer SINUMERIK 808D ADVANCED Function Manual manual chapter 12.5 for more detail information. SUB_46 - It is asynchronous subroutine to be call to read tool number, NCK variables etc.etc. Please refer chapter 2.6.2 for detail information. HTH |
Last edited by: Jen_Moderator at: 07/02/2021 12:21:26Optimized link. |
|
| 7/2/2021 12:10 PM | |
|
Posts: 8092 Rating:
|
Hello, SUB_43 - Is used to process the information from measuring probe. User can use this to calibrate probe & measure a tool. Please referSINUMERIK 808D ADVANCED Function Manualmanual chapter 12.5 for more detail information. SUB_46 - It is asynchronous subroutine to be call to read tool number, NCK variables etc.etc. Please refer chapter 2.6.2 for detail information. HTH |
This contribution was helpful to
|
|
| 7/4/2021 10:08 AM | |
|
Posts: 19 Rating:
|
Thank you very much for your quick reply |
Follow us on