SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Sinumerik 808D in ISO Mode

11/8/2018 12:32 PM	Rate (0)
nick1910 Posts: 1 Rating: (0)	Hello, I have this problem in 808 ... I now have it in ISO MODE and I have written a program in G code. The tool with the compensation I have written so ... T1D1, and when I run my program says wrong, D is not defined, but it has been offset before. What should I write in the program to recognize the tool? Thank you very much ------------------------------------------------------------------------------------------ Split from Sinumerik 808D with drive.
nick1910 Posts: 1 Rating: (0)	Last edited by: Jen_Moderator at: 11/8/2018 3:58:38 PM New subject after splitting
Suggestion To thank Quote Answer

11/22/2018 9:41 PM	Rate (0)
jaloviper Posts: 4 Rating: (0)	Hello nick1910, ISO mode is some kind of compatibility mode with Fanuc. T01 01 instead of T1 D1 should work.
jaloviper Posts: 4 Rating: (0)	Last edited by: jaloviper at: 11/22/2018 9:42:30 PM Last edited by: jaloviper at: 11/24/2018 5:12:03 PM
Suggestion To thank Quote Answer

7/4/2021 10:10 PM	Rate (0)
alfredkim74 Posts: 1 Rating: (0)	hi am using sinumerik 808D turning cnc lathe ,siemen controller, when chaning from siemen langauge to iso dialect,the machine is asking me tghe password ,since its 0-1-2-3 protected
alfredkim74 Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

7/6/2021 5:29 AM	Rate (0)
PISCEAN 2010 Posts: 8092 Rating: (884)	alfredkim74 hi am using sinumerik 808D turning cnc lathe ,siemen controller, when chaning from siemen langauge to iso dialect,the machine is asking me tghe password ,since its 0-1-2-3 protected Please contact here.
PISCEAN 2010 Posts: 8092 Rating: (884)
Suggestion To thank Quote Answer

Share this page:

Share this page on...