No. No any chance

 Hello Sir Piscean, I am new to the industry and also want to ask. Is there any possibility to assign dynamic M codes without using PLC programmer like step 7? Thank you

PISCEAN 2010

Hello,

Which is your 810D software version? Please check.

To activate auxiliary functions, you need to define MD in NC e.g. like T, M, H etc.etc. In PLC need to decode M functions & write a logic via which output can be activated for appropriate application.

SO check your NC data, PLC DB21..DB30, (M0 to M99) dynamic codes are available. (few dynamic M codes are reserved by Siemens which cannot be used e.g. M03, M04, M05, M70 etc. etc).

Hope this helps.

 

------------------------------------------------------------------------------------------
Split from Available extra M-Codes.