Hi guys! I need healp.

I need to swich outputs on and off in succession, one after the other, at no time should there be 2 or more light up, only one at a time.

My ideea was to send command signal to the next timer after the first timer goes on and off, basicaly so that the timer starts after the trigger goes on and off, but all the rellays i have found star the time from the start of the trigger not from the end of the trigger.

I have found a way with on-relay, but is there a way with off-relay so I can reset the timmer if I need to?

Thanks!

Basicaly traffic lights. I need it to turn on Q1 then off, at the same time Q1 gose off Q2 goes on, and so on. So there needs to be a cycle of Q1-on, then Q1-off and Q2-on, Q2-off and Q3-on and so on.

I did find a way with on-relay, but I want, if posible, to do it with off-delay so I can reset the times of the relays so that I restart the cycle with all on red. That part I have figured out.

My only problem comes from the fact that off-relays go on instantly after thei get triggerd and the on-relay does not have the option for reset.

Thanks, it does work, but at the end it resets itself. I want to have the option to reset, but the circuit to run in a loop. And I just realised that you actualy asked for all the details and I just didn's explain it better. My bad.

So

1)Q1-on

2)Q1-off, Q2-on

...

x)Qn-off, Q1-on

With on-relay works, no problem, but I can't reset the circuit without complitely shuting down, becasue no reset imput. I like the off-relay because it has the reset R input, and with that I can bring the hole circuit back to Q1-on and everithing else off instantly without turning it off and on again.

Thanks!

I stil have a few things to figure out with my program, but your help was immense. It's late, I am going to try again tomorow morning, it's to late for my brain to think properly. I will reply tomorow morning after I will implement this properly.

Thanks a tone!