"Feed Hold Main Axis".--I checked you picture , you programmed spindle running (2000)  but actual is 0, so find out why spindle not run, X,Y, Z are waiting for spindle running 

Syed1234

I have written a program but getting an error "Feed Hold Main Axis". I  would be grateful if someone in the forum can help me to fix this. The error is shown in the attachment. I have been to fix this but to no avail. 

Thank You in advance.

Syed1234

I have written a program but getting an error "Feed Hold Main Axis". I  would be grateful if someone in the forum can help me to fix this. The error is shown in the attachment. I have been to fix this but to no avail. 

Thank You in advance.

Hello Syed1234, 

Please post your query in new topic instead posting it in old topic.

1. Alarm no 701116 & 702035 are PLC alarms developed by OEM or machine builder & not Siemens system alarm. As such please check your machine maintenance manual or refer PLC logic & find out why those alarm are triggered?

2. Is ATC operational? Please check if T9 is called ON since from your program it looks like tool no 9 is called on via ATC. If ATC or turret is failed, spindle could not be enabled.

Hope this helps.