Hello there!. I have a micromaster 6SE3013-4BA00 i bought as a replace for a KOORDINAT M/MP. Following the troobleshooting guide for the koordinat under the "replacing micromaster instructions" I come to the step where setting the P009 and P910 parameters is needed. Heres my question, im able to set the parameter P009 to the requested one (0003) in order to be able to chenge other parameters, however im not able  to set the P910 to "0002" since the micromaster only allows "0000" and "0001" options.

After some reserch and tests I found out the micromaster im trying to configure has an older software version which makes me think thats the problem, since its the only difference. Im wondering if it possible to update the software version from "version 1004" to atleast " version 1007"

i will attach some pic of the micromaster i have and request for manuals if possible.

Hi

P910 settings were:

0 = local

1 = remote

3 = Local  control, with serial control for frequency

4 = Serial control, with local control for frequency

If settings 3 and 4 are not available then the device which you have is an earlier version, as you have discovered.

Software upgrade was not available for this drive, this would be possible by replacing the top circuit board, but I cannot confirm this looking at old records.

This drive was manufactured at Congleton, UK, in 1998, week 42, Friday, and looks good.

Tractor

Yes I have this completely wrong,,

XA = Congleton, UK.

E = 1994.

4 = Month 4, April.

25 = day 25.

Tractor