Hi

I lost the software on my mechine, can you Please send me your plc software backup for this machine 

 Thank you 

Agron34

Dear Experts,

Have a problem with machine controlled by 840D (MMC100). Problem is after power-on "2001 Plc Not Start-Up" alarm occurred. When alarm occurred "green led on" and status "6" both on PLC and NCK. 

Whereupon reset the PLC via S4 switch and have tried reload the PLC files. The file transfer operation has stop after load %78 of file (192420 of 247000). Have to reset the PLC and tried reload the file again and again. Despite attempts many times but, unfortunately file transfer has stop approximately on same point.  

Does anybody know what can i do?

Sincerely.

------------------------------------------------------------------------------------------
Split from 2001 PLC Has Not Start-up.

Hi

What you did to fix this problem Please send me the step of solution one my email [snip]

Thank you 

Hello Moon Face,

please don't post twice for the same problem.

And don't write personal information e.g. email address in posts. It's not allowed at the forum rules ...

Closed cause question posted twice.

The second thread with the subject Lost software is published within the conferenceSINUMERIK CNC automation systems.