I need to read something from NC:

"NCVARS_STAT".V_M_r0035_35 is:

I got this error: mFb2Status = 1025 (high byte 4, low byte 1) --> so, access error on Addr4 (if I use NumVar = 3 it works)

I'm trying to read parameter r0035 on axis 6 (my spindle)

Where I'm wrong?

Thank you, Claudio.

Two issues:

• You cannot mix different signals in one FB2/3-call (here: CHAN-Data and Drive-Data). Need to split that in different FB2/3-calls
• V6-issue: The right number ist the Drive-number, NOT the axis number! (dont know Your configuration)

1) Ok, thank you.

2) Here I was in doubt, nice thank you. The drive is the 4th.

CNC600

Two issues:

• You cannot mix different signals in one FB2/3-call (here: CHAN-Data and Drive-Data). Need to split that in different FB2/3-calls
• V6-issue: The right number ist the Drive-number, NOT the axis number! (dont know Your configuration)

 Try to guess .... it works.

Again, thank you.

Claudio.

Thanks for Your response!