Hi,

I also have the same problem, I used iot2050 advanced to connect the power and monitor, the power light is green. STAT is green at first and then it will turn red, and the monitor is not receiving signal. I pressed Reset and STAT will turn green briefly and then turn red again. How can I solve this problem?

best wishes

FürBA

------------------------------------------------------------------------------------------
Split from IOT2050 doesn't start well.

Hi,

I found the problem that my iot2050 advanced is FS4.I will install the System for it and see if it works...

best regards 

FürBA

Hi,

I installed the IOT2050_Example_Image_V1.2.2.zip (780,6 MB) (SHA-256) for the Mirko SD card yesterday and loaded it into the iot2050. but this does not seem to work. I can't access it via local connection or remote connection.When connected, the STAT light first lights up green and then goes out.I have tried replacing the SD card but it didnt work.

I don't know if there is a problem with the following situation.I tried to open the downloaded IOT2050_Example_Image_V1.2.2.zip (780,6 MB) (SHA-256) file on my own computer and was told that the file was corrupt. But I re-downloaded it still in this case. Currently I am actively looking for the reason.If I could get some advice I would be very grateful.

best wishes

FürBA

Hi,

here is FürBA. I compared the downloaded zip with the SHA256 from the download site and they are consistent.Thinking about the next step.

best wishes

FürBA