SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

PCS7 Simocode Faceplate empty in the graphic desingner.

12/5/2011 1:45 PM	Rate (0)
MicroMan Platinum Member Joined: 11/29/2011 Last visit: 2/4/2025 Posts: 1362 Rating: (233)	Dear Experts, I have an issue I can not deal with. I had to install a new PCS7 test system for my customer. The system started up fine, but there is one small issue with Simocode. The problem is that the faceplate jumps up empty (says: @faceplate). All other faceplates working fine. Do you have any idea what it can be with Simocode? Thank your help in advance! Microman
	- What you read here, please check with manuals and your requirements. - Do not forget to Test, Test and Test... - If the post is helpful, please RATE it! MicroMan
Suggestion To thank Quote Answer

12/6/2011 10:40 AM	Rate (0)
Thunderstorm Gold Expert Joined: 10/26/2011 Last visit: 1/13/2026 Posts: 766 Rating: (195)	Hello MicroMan, how many "@PCS7Typicals..."templates do you have? The system can only handleten @PCS7Typical templates. If you have more, the system takes only the firstten and ignores the following templates. Regards Thunderstorm
	SIMATIC PCS 7 - Overview SIMATIC PCS neo - Overview Here you have direct access to the most important technical information and solutions
Suggestion To thank Quote Answer

6/2/2014 11:57 AM	Rate (0)
MicroMan Platinum Member Joined: 11/29/2011 Last visit: 2/4/2025 Posts: 1362 Rating: (233)	Hi, The issue was that it was an old Simocode SW and the faceplates had to be registered manually. After I registered the Simocode faceplates manually it started work like a swiss clock. Cheers!
	- What you read here, please check with manuals and your requirements. - Do not forget to Test, Test and Test... - If the post is helpful, please RATE it! MicroMan
Suggestion To thank Quote Answer

6/8/2022 9:42 AM	Rate (0)
EBM101 Posts: 53 Rating: (0)	MicroMan Hi, The issue was that it was an old Simocode SW and the faceplates had to be registered manually. After I registered the Simocode faceplates manually it started work like a swiss clock. Cheers! Hi MicroMan, May I know how did you registered manually the simocode? Thanks in advance
EBM101 Posts: 53 Rating: (0)
Suggestion To thank Quote Answer

Share this page:

Share this page on...