Hello everybody

I'm using simosim with X127 interface to simulate control and I did establish an HMI connection with the same interface x127 (see the fig attached )

Unfortunately, I can not see any data exchange from the HMI WinCC simulation

------------------------------------------------------------------------------------------
Split from Simotion simulation with HMI simulation.

hello and thank you for attending to my question.

I still can't solve the problem:

1.

Simosim virtual ethernet adapter: 192.168.11.150

HMI device: 192.168.11.2

PLC: 192.168.11.22

2.  I can simulate the PLC program only with simosim but not with WinCC simulation.  I can address and see the plc variables from HMI but it's not possible to see any change from the HMI simulation.  The setting in scout for WinCC is according to your specification

Hello,

Yes, I did it as you can see in the figure below.

The Simotion program only works from scout simulation and not from HMI

What else can I do to solve this issue?

Thanks

Thank you, ChristoPhd

It works now!