Hello,
I've try new panel HMI Unified MTP700.
I have 2 problems in this new device:

- Keyboard format: I add format "{F1} s" but the keyboard have also symbols and not only number. How can I change the keyboard in ONLY numerics?

- Show the parameter changing with keyboard. How can I show the parameter when I'm changing that? (like old TP700 Comfort)

Thank you

Regards

mic234

Hello,
I've try new panel HMI Unified MTP700.
I have 2 problems in this new device:

- Keyboard format: I add format "{F1} s" but the keyboard have also symbols and not only number. How can I change the keyboard in ONLY numerics?

- Show the parameter changing with keyboard. How can I show the parameter when I'm changing that? (like old TP700 Comfort)

Thank you

Regards

good luck

I've also noticed a weid behaviour:

If you put {F2} xxxx or {F2}x or {F2} ºC when trying to put a value in the field the keyboard appears (sometimes over the field) but the numeric value is displayed and you only have to type the new number. For example, 13.2 ºC then I push 1, 3, ".", 3, enter and it changes to 13.3 ºC

But when using {F2} barg or {F2} Nm3/h or {I} min the keyboard shows the numeric AND the unit, so if you try to directly put a numer it takes the whole word, for example, a pressure of 13.2 barg is show in keyboard as 13.2bar so if I push 1 keyboard is showing 13.2barg1. It is required to press the delete key before puttiing the new value.

And as depending on field position you cannot see the field, changing it is quite tricky.

Waiting for some answers to this thread before raising a Technical Support query.

Oscar G. Flores

I've also noticed a weid behaviour:

If you put {F2} xxxx or {F2}x or {F2} ºC when trying to put a value in the field the keyboard appears (sometimes over the field) but the numeric value is displayed and you only have to type the new number. For example, 13.2 ºC then I push 1, 3, ".", 3, enter and it changes to 13.3 ºC

But when using {F2} barg or {F2} Nm3/h or {I} min the keyboard shows the numeric AND the unit, so if you try to directly put a numer it takes the whole word, for example, a pressure of 13.2 barg is show in keyboard as 13.2bar so if I push 1 keyboard is showing 13.2barg1. It is required to press the delete key before puttiing the new value.

And as depending on field position you cannot see the field, changing it is quite tricky.

Waiting for some answers to this thread before raising a Technical Support query.

 After updating to panel version 17.0.0.1 both problems are solved: now the screen "moves" to have the field out of keyboard zone and units are no longer displayed during typing.