hello there

I attached a picture... The DB Pointer is 971... what STL code can I use inside to move 

from this DB [971 - INT] into Funkt_DB

on the top network 5 I want to do this move but inside the FC itself...

Have a look at "Memory Indirect Addressing" shown on:
[LINK] http://www.plcdev.com/siemens_s7_indirect_addressing

More resources mentioned here:
[LINK] Add many data from many DB

I dont get this...

I want to simply say

Transfer_val  == array[1...10] of int

counter_val == int

L  counter_val

T  Transfer_val [counter_val]

it stays red I cannot let the STL accept it...

in Tia I can just load this Cnt into

TZ[1].Takt[#Cnt]      

but Step 7 not

my Cnt is my pointer Int

what code will step 7 understand?

Switch_639

in Tia I can just load this Cnt into

TZ[1].Takt[#Cnt]      

but Step 7 not

my Cnt is my pointer Int

what code will step 7 understand?

It is clear that I have not understood your question correctly the first time.

There are difference between the S7-300 / S7-400 and the S7-1200 / S7-1500. It is not about Step7 in TIA Portal. You will need to use SCL or use indirect addressing in STL.

Siemens did however publish some code that can extract
Do you ever rate posts that was helpful to you?

how does that code look like or where could i find examples?

STL isn't my strong suite