SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

NetPro function "Connection Status" is unavailable

7/10/2023 12:31 AM	Rate (0)
vkykypy3o Member Joined: 8/18/2022 Last visit: 1/14/2026 Posts: 2 Rating: (0)	Hello! Help me please to solve the problem with NetPro: it does not allow function "Connection Status". The PC Station compiles and downloads without any errors. Both modules "Application" and "IE General" are in RUN. Hardware configuration of this PC Station goes Online without any problems. There was a project in STEP 7 V5.5 (Windows XP) which normally provide this functionality, but in STEP 7 V5.7 (Windows 10) the function "Connection Status" for PC Station in this project became unavailable (in other project with CPU S7-400 it works fine). I`ve tried (unsuccessfully): Save project in STEP 7 V5.7 with reorganization Replace both modules with the last version of catalog Reconfigure PC Station with PLC==>Configure

Suggestion To thank Quote Answer

7/14/2023 12:21 PM	Rate (0)
Murof Platinum Member Joined: 8/3/2009 Last visit: 1/16/2026 Posts: 16644 Rating: (1944)	Hello vkykypy3o Check out this manual Chapter 11.10 https://support.industry.siemens.com/cs/ww/en/view/109751824 Bye Murof
	If this Information really helps, you could use the Rate function
Suggestion To thank Quote Answer

7/14/2023 2:56 PM	Rate (0)
vkykypy3o Member Joined: 8/18/2022 Last visit: 1/14/2026 Posts: 2 Rating: (0)	I've read it. The same requirements are given in Help of NetPro: • Displaying the connection status is possible only for the local endpoint of a connection, for example, for a CPU that is selected in the network view. Yes, module "Application" is selected, as it was selected in STEP 7 V5.5 (Windows XP) • The module must support the connection status. (Possible as of 10/99, this performance feature is documented in the instruction list of the CPU. The CPU must support the SSL ID 0x36 "Connection-Specific Diagnostics."). Yes, I expect that SIMATIC NET PC Software V18 supports this function no less than SIMATIC NET PC Software V6.3 (Windows XP) • There is an online connection to the connection end point. Yes, I described it above • If the connections that are involved are connections that were configured with an optional package, you will need the optional package in order to display the status. No, there are no optional package is used in this project • There is a project for the network configuration on the programming device, or you have uploaded the station to the programming device (menu command PLC > Upload). Yes, this project have been compiled and downloaded to PC Station without any errors Any other suggestions?

Suggestion To thank Quote Answer

Share this page:

Share this page on...