I would like to request technical assistance on G120X ( 6SL3220-2YE24-0UB0), commissioning parameters for a Permanent Magnet Synchronous Motors (PMSMs) application.
This motor is used for driving an exhaust fan ( Motor Connect to Fan by Direct Shaft ).
The operation is like the Start / Stop command for the VFD will come from the Boiler controller
( VFC ) and the Speed reference is also from the Boiler controller ( 0-10 V).
The motor nameplate Details are attached.

I tried to drive the motor without load ( Only Connecting the Motor ), The motor functioned properly but with the load ( Connecting the exhaust Fan to the motor shaft ), faced an issue like the Motor Block
( F7900 ), I tried all the Remedial actions suggested in the manual.

I made sure that the Exhaust fan connected to the motor was freely rotating. Note that there is a possibility that the exhaust fan may rotate automatically without providing any voltage from VFD due to airflow through the duct.

Parameters Executed: -

Factory Reset:

P0010-30
P970- 1
STEP 1: Quick commissioning:
P0010- 1 (Quick Commissioning)
P0096- 2 (Dynamic Drive control)
P0300- 2 (Synchronous motor)
P0304- 400 V (Rated motor voltage)
P0305- 5.90A (Rated Amp)
P0307- 2.2 (kw)
P0308- 0 (Power factor)
P0310- 184 Hz (Frequency)
P0311- 2208 ( RPM )
P3900-3 (End Quick commissioning)
P1900 –2 (Motor Identification )

STEP 2:
P0350- 0.65 Ohm (Motor stator resistance cold) (Ohms)
P0356- 12mH (Motor stator leakage inductance ) Ld.
P0357- 12mH (Motor stator inductance d axis ) Lq