Have you tried using Sinamics Starter, going through the commissioning wizard where you have the opportunity to realize your wishes to the G120C?

Farr J

Hi, Please could you provide the best simple setup to drive a small 1.70 kW pump motor using a Simanics G120C from a 4-20 mA externally derived (process meter) we are using terminals 3 & 4 for 4-20 mA. we are triggering the start through D1.0  terminal 5. from terminal 9. we have set up 4-20 on the keypad (parameters 0752 & 0755. (0-100% and have linked terminals 34 & 69 . we can run motor in hand but not through our process meter 4-20 mA. Please help :)

Hi Thanks, we will try and go through methodically through the set up parameters. There must be a simple reason, thanks again

Farr J