Hi Everyone,

I'm looking to create a Network Share using HIM Option+. Has anyone successfully created a Network Share before?

I've followed the "Simatic HMI Option Plus V20" manual section 3.12 to the letter but still have difficulty in seeing a share on the faceplate (Figure 3-47 of that manual).

I suspect that the issue may be with the Script integrating with the HMI & Application. I have an image attached.

All suggestions welcome.

Regards,

Robert

Hi ROH2019,

I'm experiencing the same problem, no connection to the shared folder.

Did you solve the issue or anyone else?

Hi!

Could this help you?

https://support.industry.siemens.com/cs/ww/en/view/92346478

Br!

Hi Serendipity0,

I found the document you indicated me helpful; so far I can transfer files from panel to server via HMI Option + Manager only, there's no way to make HMI Option Plus Network Shares work, since SMB 1.0 protocol has been deactivated. The HMI Option + Manager is running on Windows Server 2016 and I can work with V3.0 only, as I can see V3.1 is not supported by Windows Server yet. [snip]

New question published by collins77 is split to a separate thread with the subject how many connections could HMI Option + Manager support?.

Best regards
Jen_Moderator