SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

SIN802D-power module

6/22/2009 11:37 AM	Rate (0)
Liliana Posts: 22 Rating: (1)	Hi,I have a Turning vertical lathe with two linear axes and one analog spindle and SINUMERIK 802D.Motors for axes are the type 1FK7 100-8AF71-1AA0.For the axis is a double power module 6SN1123-1AB00-0CA2.Customer wishes to mounted on linear axes, the linear measurement system.I can not connect to this power-module, the directly linear measurement system.I have in stock two power-modules type 6SN1123-1AA0-0BA1. Can I use this module for motors above?Iri
Liliana Posts: 22 Rating: (1)
Suggestion To thank Quote Answer

6/22/2009 4:27 PM	Rate (0)
Dave Posts: 271 Rating: (29)	Hello Iri, If you use a 9 Amp drive like you suggest, the stall torque of the motor will reduce from 18 Nm to 14.5 Nm. The peak torque available will be about 29 Nm. Hope this helps...
Dave Posts: 271 Rating: (29)
Suggestion To thank Quote Answer

6/22/2009 4:31 PM	Rate (0)
pfuser Gold Member Joined: 9/18/2006 Last visit: 12/8/2025 Posts: 596 Rating: (64)	Hi. No. It is desirable -0CA1. Best regards. Attachment Rated output.JPG (247 Downloads)

Suggestion To thank Quote Answer

6/22/2009 10:16 PM	Rate (0)
Dave Posts: 271 Rating: (29)	Hello Iri, Another thing to consider, if you use single axis power modules, you'll need two control units. Simodrive 611UEcontrollers will work fine, but the torque output is lower nonetheless. The linear feedback device can connect to the second axis of either control unit; however, you'll need to assure that the feedback device is 1 volt-peak-to-peak sine output. Hope this helps...
Dave Posts: 271 Rating: (29)
Suggestion To thank Quote Answer

6/23/2009 3:53 PM	Rate (0)
pfuser Gold Member Joined: 9/18/2006 Last visit: 12/8/2025 Posts: 596 Rating: (64)	Hi. Can you will use ADI4 for linear measuring systems. At SINUMERIK 802D both linear measuring systems can be connected. A SDBs enable the use of an ADI4 module with three 611U modules in two variants. Best regards. Файл: ADI4 Attachment ADI4_SDB for DMS.pdf (295 Downloads)

Suggestion To thank Quote Answer

Share this page:

Share this page on...